Back to the Mod Project

1/24/2002


Here's some pictures of engine vents Pat decided he needed after he saw similar vents selling unpainted on Erebuni's website fo $75 US a side. :) To make these, he just traced an outline on the bottom of the engine covers with a marker and a washer. Next, he dremeled the line wasting many a cut off wheel. To finish off, some rubber flexible molding from a window shop was used as trim. The mesh was attatched with black silicone on the underside. Cheap and easy, and should allow heat to dissapate from the engine faster, dropping temps a little bit.